Generac FG0072190 - Standby Gas Generator 20kVA 3 Phase Air Cooled

Specifications

• Generator
  • Rated Maximum Continuous Power Capacity (LP): 20,000 VA
  • Rated Maximum Continuous Power Capacity (NG): 17,000 VA
  • Rated Voltage: 380/400/416
  • Rated Maximum Continuous Load Current – 380 Volts (LP/NG): 30.4/25.8
  • Total Harmonic Distortion: Less than 5%
  • Main line circuit breaker: 32 amp
  • Phase: 3
  • Number of rotor poles: 2
  • Rated AC frequency: 50 Hz
  • Power factor: 0.8
  • Battery requirement (not included): 12 volts, Group 26R 540 CCA Minimum or Group 35AGM 650 CCA Minimum
  • Unit weight (lb / kg): 486 / 220
  • Dimensions (L x W x H) (cm / in): 121.9 x 63.5 x 73.7 / 48 x 25 x 29
  • Sound output in dB(A) at 7 m (23 ft) with generator set operating at normal load**: 65
  • Sound output in dB(A) at 7 m (23 ft) with generator set in Quiet-Test™ low-speed exercise mode**: 59
  • Exercise duration: 5 min
• Engine
  • Type of Engine: GENERAC G-FORCE 1000 SERIES
  • Number of Cylinders: 2
  • Displacement: 999 cc
  • Cylinder Block: Aluminum w/ Cast Iron Sleeve
  • Valve Arrangement: Overhead Valve 
  • Ignition System: Solid-state w/ Magneto
  • Governor System: Electronic
  • Compression Ratio: 9.5:1
  • Starter: 12 VDC
  • Oil Capacity Including Filter: 1.9 qt/1.8 L
  • Operating rpm: 3,000
  • Fuel Consumption
    • Natural Gas ft³/hr (m³/hr)
      • 1/2 Load: 152 (4.3)
      • Full Load: 229 (6.48)
    • Liquid Propane ft3/hr (gal/hr) [l/hr]
      • 1/2 Load: 68.8 (1.89) [7.16]
      • Full Load: 106.8 (2.94) [11.11]

Note: Required fuel pressure to generator fuel inlet at all load ranges - 0.87–1.74 kPa (3.5–7 in water column) for NG, 2.49–2.99 kPa (10–12 in water column) for LP gas For BTU content, multiply ft3/hr x 2500 (LP) or ft3/hr x 1000 (NG). For Megajoule content, multiply m³/hr x 93.15 (LP) or m³/hr x 37.26 (NG).

Controls

• Two-Line Plain Text Multilingual LCD Simple user interface for ease of operation.
• Mode buttons
  • Auto: Automatic start on utility failure. 7 day exerciser.
  • Manual: Start with starter control, unit stays on. If utility fails, transfer to load takes
  • Off: Stops unit. Power is removed. Control and charger still operate.
• Ready to Run/Maintenance messages Standard
• Engine Run Hours indication Standard
• Programmable start delay between 2–1500 seconds Standard (programmable by dealer only)
• Utility Voltage Loss /Return to Utility adjustable (brownout setting) From 222–296 V /350–374 V
• Future Set Capable Exerciser/Exercise Set Error warning Standard
• Run/Alarm/Maintenance logs 50 events each
• Engine start sequence Cyclic cranking: 16 sec on, 7 rest (90 sec maximum duration).
• Starter lock-out Starter cannot re-engage until 5 sec after engine has stopped.
• Smart battery charger Standard
• Charger Fault/Missing AC warning Standard
• Low Battery/Battery Problem Protection and Battery Condition indication Standard
• Automatic Voltage Regulation with Over and Under Voltage protection Standard
• Under-Frequency/Overload/Stepper Overcurrent protection Standard
• Safety Fused/Fuse Problem protection Standard
• Automatic Low Oil Pressure/High Oil Temperature shutdown Standard
• Overcrank/Overspeed (@ 72 Hz)/rpm Sense Loss shutdown Standard
• High Engine Temperature shutdown Standard
• Internal Fault/Incorrect Wiring protection Standard
• Common external fault capability Standard

**Sound levels are taken from the front of the generator. Sound levels taken from other sides of the generator may be higher depending on installation parameters. Rating definitions - Standby: Applicable for supplying emergency power for the duration of the utility power outage. No overload capability is available for this rating. (All ratings in accordance with BS5514, ISO3046 and DIN6271). * Maximum kilovolt amps and current are subject to and limited by such factors as fuel BTU/megajoule content, ambient temperature, altitude, engine power and condition, etc. Maximum power decreases approximately 3.5% for each 304.8 m (1,000 ft) above sea level; and also will decrease approximately 1% for each 6 °C (10 °F) above 16 °C (60 °F).